How stick your race motorcycle with electroluminescent numbers

03 Mar How stick your race motorcycle with electroluminescent numbers

Get basics to prepare your seasons properly.

Buy light-up race numbers >

Prerequisites
Strategic choices

Motorcycle kits are available with two race numbers and it is possible to opt for one or two power supplies. By default, the kit includes one solid block 12V for 2 stickers.
The vast majority of regulations are consistent with the Electroluminescent store online editor, which allows you to build all custom designs wanted.

Location

Race numbers can be rewound around a tube and its flexibility allows you to stick it on any motorcycle. For example,FIM recommend installation on the front and on the rear of vehicles. For more information, refer to the coordinators' instructions of the event you are applying for.

Composition
The installation kit consists of a power supply, adapted plugs and adhesive race number.

This power supplies example show sizes between competition power supplies

Race numbers

Build in Extra resistant resin, the solid bloc may be installed under fairing, electrical compartments or anywhere you need it to fit.
Power supplies are 12 V polarized from the battery but the outputs are apolar . Solid block size depends on total area - single, double or triple numbers .

Electroluminescent stick numbers

Numbers regular contour

Numbers contour design

Motorcycle race numbers are still back glue side, so it is necessary to peel off before applying. Clean the application surface, slightly heat the back of the electroluminescent race number to make it more flexible and then, install directly without water. It is possible to change the side of the flat wires output. Avoid back output which tends to break too easily. If you just want numbers shape without frame, it is also available.

Kit installation